26. Which part of the laser printer should NOT be exposed to sunlight?
A. Transfer corona assembly
B. PC drum
C. Primary corona wire
D. Toner cartridge
E. None of the above
27. After doing a low-level format, what would be the next step in configuring the hard drive in a system?
A. Format DOS partition
B. Install operating system
C. Configure DMA channel and back-up interrupt
D. Partition had disk
E. None of the above
28. Resistance is measured in?
A. Volts
B. Amps
C. Watts
D. Ohms
E. None of the above
29. What command is used to reset a MODEM when using the “AT Command Set”?
A. ATR
B. ATZ
C. DTR
D. DCE
E. None of the above
30. When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to:
A. B0007
B. An unused SCSI address
C. The same address as the SCSI device before the CD-ROM
D. SCSI ID=1
E. None of the above